A linear drain in the tub to shower conversion for the bathroom is a great way to save water, improve the efficiency of your pipes, and rejuvenate a dated look. Most homes do not have an easily accessible linear drain in their bathroom so performing this installation can be a daunting task. If you are unsure about how to set up this type of shower conversion in Fenton, MO, follow these guidelines on how to create an access point for your incoming water supply at your sink as well as instructions on how to properly remove and install pieces of this pipe system for your drainage.
Remove the Existing Faucet and Sink
The first step to creating an access point in your bathroom is to remove your existing sink and faucet. Check underneath the sink area for any water supply hoses connected directly to the supply pipes. If you notice any hoses are connected, use a wrench to loosen them from the wall. After this, use pliers to disconnect any associated metal clamps since these will be needed in the following steps of this procedure.
Find the Location of the Linear Drain in the Toilet
Once your faucet, sink, and associated hoses are removed from the wall, turn on your water supply to observe where your incoming water comes back into the house. You will be able to find this location by making sure that it is coming from a fixture that has an exposed supply pipe connected to a wall with no apparent access point for it. The location of your incoming water supply will be an area that you can easily access in order to remove and replace pieces of the linear drain.
Cut Out a New Section of Drywall
Once you have found the location of your incoming water supply, use a drywall saw to cut out a section of drywall that is as large as the diameter of the linear drain pipe. Be sure to cut the section of drywall above any exposed water supply hoses so you will have enough room to reattach them in the following steps.